![]() I found "Teflon shrink" in Ebay 3-4$ and "PTFE shrink" around 1-1. Every purchase you make puts money in an artist’s pocket. Find Multipass-inspired gifts and merchandise printed on quality products one at a time in socially responsible ways. Is PTFE heat shrink will be good enough as the teflon? T-shirts, stickers, wall art, home decor, and more designed and sold by independent artists. Stunning smooth response, so much so it may be too smooth for some! This should be done in a well ventilated area because it releases a small amount of hydrogen fluoride.įinally got round to doing this mod on my Taranis X9D model B01. In my case it would only turn where the heatgun was pointed so I made sure to cover the whole thing. It took a couple minutes with a heat gun on high while holding it with a pair of needle nose pliers while flipping it over to heat both sides evenly to get it there. When this happens it becomes almost invisible and you can clearly see the throttle spring through it. It is mechanically stretched PTFE and it needs to be heated to it's gel state to recover it's original shape. You need to heat this stuff to 624 ✯ to shrink it. It's better than PTFE mouse tape because it's also works with a ratcheted throttle. This eliminates stiction from the throttle and also makes it glassy smooth. Measure the width then choose the closest size that will fit by taking the circumference and dividing by half. If you are doing this on some other radio you might need larger tubing, it just barely fits the FrSky throttle spring. Obtained some teflon 2.5mm diameter shrink tubing from Ebay. Did this on my Horus X10S but should work with any FrSky radio (well any radio actually) This mod is so good they should just come stock like this from FrSky. Which I do now just as I check other lipos. So the battery scale I use is 7.8 to 7.9, as a final failsafe if I don't check the lipo inside 14hours of flying. It dropped a bit as the lipo came down, like a few points. I'll check the voltage within 14 hours, my quads don't last that long and I need to get the charger out, so need to check my lipos anyway.īy the rescaling, I meant that I'd seen the v drop off the first time when I hadn't check the voltage on the lipo since forever. Ok, I'll only use half the capacity, 14 hours. Using that as a conservative minimum constant voltage, I've at least 104kj to play with.ġ04kj = 1 j/s for 104000 seconds or 28 hours constant. ![]() ![]() Bag of fag packet, 3s x 2650 mah gives me at least 11v. Theres large enough mah that there is margin, ie consumed mah below 11.5v or whichever to think its getting a bit low and top it up. So takes a few seconds to test the lipo powering the tx. I check their voltages after flying and before charging its good practice to and means they're similar when charged in parallel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |